inserindo o canudo do cilindro de gás na glande para uma bora ereçao.
15,331 79%
,jpeg/023/823/227/1280x720.c.jpg.v1695833005)
Com o cilindro de gás oxigênio implantei o canudo na glade e depois foram muitas gozadas extremas.
há 1 ano
,jpeg/024/719/057/1280x720.17170087.jpg)
,jpeg/024/714/061/1280x720.17169031.jpg)
,jpeg/025/294/353/1280x720.17287715.jpg)
,jpeg/025/197/724/1280x720.17269001.jpg)
,jpeg/025/076/514/1280x720.17246158.jpg)
,jpeg/025/048/700/1280x720.17243089.jpg)
,jpeg/025/294/315/1280x720.17279163.jpg)
,jpeg/025/189/065/v2/320x180.204.jpg)
,jpeg/011/174/502/1280x720.2.jpg)
,jpeg/024/991/443/1280x720.17229764.jpg)
,jpeg/024/862/111/1280x720.17200173.jpg)
Comentários
4
Por favor, inicie sessão ou registe-se para publicar comentários
Yayyy!!! You tried! Thank you. Melt the end with a lighter slightly to round off the sharp edge of that plastic. Also, you may want to cut the last 1/4" off the end first because I think the second graduation up will fit you just fine, perfectly in fact. That first stem is too long for now. Just be sure to melt the edges slightly with a lighter, rounding the edges off while it's still maliable with your fingers. Let it cool then send it in a little slowly going about half an inch. Tape it there if you need, which will free that hand to use elsewhere. Good job bro. Hot to finally see this . I knew you could do it. HOTAF
Responder